Large Stained Glass Spider Web Corner Sun Catcher- Clear Iridescent

Hand made stained glass corner web. Measures 7" x 9". You can easily mount your web in the corner of your window, door way, porch arch or anywhere you have a 90 degree angle. These webs collect and distribute light making them an excellent, eye catching piece.

You can display your web for the Fall & Halloween season or you can just *dust it off* and admire it year round!

Webs are simple to mount by using thumb tacks, staples or finish nails though the eyelets already secured to the edges of the web on either sides.

Still have questions? Others might too! Please message us and help us to improve our product descriptions.

Stained Glass Care Instructions:

Your stained glass piece has been thoroughly cleaned, polished and protected with a wax coating. From time to time your piece may need some dusting. Simply use a clean, lint free, damp cloth to wipe down your piece. It is not recommended to use any chemical window cleaners as they may damage the finish.

Occasionally, depending on the environment your piece may oxidize and develop a white, dusty substance on the solder. This can be corrected using a soft cloth and a small amount of liquid car wax. Never use an abrasive cleaner or applicator.

Unless stated otherwise, all stained glass contains LEAD. Although it has been sealed with wax, always follow lead safety instructions when handling your piece. Wash your hands with warm soapy water after cleaning/touching. Lead contact poses a health issue if inhaled or ingested. Washing your hands after handling is considered a sufficient precaution to prevent unwanted exposure.

Stained Glass Hanging Instructions:

-Choose a sturdy wood or drywall/plaster structure. If you are hanging a corner piece, be sure to choose a 90 degree angle. (If you are hanging in a door way or window, check to see that the door or window will still be able to open and close freely once your piece is in place.)

-Hold your piece in place and mark the center of the eyelets where the screws will go using a felt tip marker or pencil.

-Set your glass down in a safe place and with a few turns, start the provided screws into the places you’ve marked using a screw driver.

-Remove the screws and hold your glass piece back up to the place you marked to hang it.

- Gently place the screws through the eyelets. Using only a screw driver - by hand (not a screw gun) and turn the screws into the holes you’ve already started. Take care to hold your piece securely until all the screws have been applied. Do not over tighten as you may damage the piece.

-Stand back and admire your new piece!